NEC Univerge SV8100 Features And Specifications Manual page 663

UNIVERGE SV8100
Program
Program Name
Number
44-02-03 Dial Analysis Table for ARS/F-
Route Access – Additional Data
44-05-01 ARS/F-Route Table – Trunk
Group Number
44-05-09 ARS/F-Route Table – Maximum
Digit
84-06-01 PVA Data Setting – RTP Port
Number
84-06-02 PVA Data Setting – RTCP Port
Number
84-06-04 PVA Data Setting – Fract Lost
Threshold
84-06-05 PVA Data Setting – Packets Lost
Threshold
84-06-07 PVA Data Setting – Jitter
Threshold
84-06-09 PVA Data Setting – Delay LSR
Threshold
84-06-16 VoIP Info – IMCP Redirect
SV8100 Features and Specifications Manual
Description/Comments
If a Service Type is selected in
Program 44-02-02, set the
additional data, if required, for the
Pre-Transaction Table for
selecting ARS/F-Route (24 digits
#
max: 1~9, 0 , @). To enter a
wild card/don't care digit, press
Line Key 1 to enter an @.
Assign the trunk group to be used
by the ARS/F-Route Table.
Input the maximum number of
digits to send when using the
F-Route.
Use this program to define the
Media Gateway starting RTP Port
Number.
Use this program to define the
Media Gateway Starting RTCP
Port Number . The RTCP Port
Number must be the (RTP port
number + 1).
Use this program to define the
fractional lost threshold – this data
will be sent to the UNIVERGE
SV8100 CD-CP00-AU when the
value exceeds the defined value.
Use this program to define the
packet lost threshold – this data
will be sent to the UNIVERGE
SV8100 CD-CP00-AU when the
value exceeds the defined value.
Use this program to define the
Jitter Threshold – this data will be
sent to the UNIVERGE SV8100
CD-CP00-AU when the value
exceeds the defined value.
Use this program to define the
Delay threshold – this data will be
sent to the UNIVERGE SV8100
CD-CP00-AU when the value
exceeds the defined value.
The IPLA daughter board supports
sending the Internet Message
Control Protocol (IMCP) redirect
message.
Assigned Data
1 = Delete Digit = 0~255
(255 : Delete All Digits)
2 = 0~500
(0 = No Setting)
3 = Dial Extension
Analyze Table Number =
0~4
(0 = No Setting)
(default = 0)
0~100, 255
0 = No Setting
255 = Extension Call
(default = 0)
0~24
(default = 0)
0~65535
(default = 10020)
RTP Port Number + 1
(default = 10021)
0~100%
(default = 0)
0~16777215
(default = 0)
0~4294967295
(seconds)
(default = 0)
0~4294967295
(default = 0)
0=No
1=Yes
(default = 0)
Issue 1.0
Level
1 2 3
2 - 639