NEC Univerge SV8100 Features And Specifications Manual page 1099

UNIVERGE SV8100
Program
Program Name
Number
34-01-01 E&M Tie Line Basic Setup – DID/
E&M Start Signaling
34-01-02 E&M Tie Line Basic Setup –
Receive Dial Type for E&M Tie
Line
34-01-03 E&M Tie Line Basic Setup – E&M
Dial-In Mode
34-01-04 E&M Tie Line Basic Setup – E&M
Line Dial Tone
34-02-01 E&M Tie Line Class of Service
34-09-01 ANI/DNIS Service Options –
Receive Format
34-09-02 ANI/DNIS Service Options –
Delimiter Dial Code
34-09-03 ANI/DNIS Service Options –
Route Setup of Receive Dial
SV8100 Features and Specifications Manual
Description/Comments
For each ANI/DNIS trunk, set the
start signaling mode to 1 (wink
start).
For DID and tie trunks, use this
option to set the trunk signaling
type (Dial Pulse or DTMF)
Determine if the incoming Tie Line
call should be directed as an
intercom call (0) or if it should
follow the DID Translation Table in
Program 22-11 (1).
Enter 1 if the Tie Line should send
dial tone to the calling system after
the call is set up. Enter 0 if the Tie
Line should not send dial tone.
Assign a Class of Service (1~15) to
a Tie Line. The Class of Service
options are defined in Program
20-14. For each Tie Line, you
make a separate entry for each
Night Service mode.
Use this option to specify the
format of the ANI/DNIS data
received from the Telco. Make sure
your entry is compatible with the
service the Telco provides (4 =
ANI DNIS [ = Delimiter
Code]).
If PRG34-01-02 is selected to
2 (MF), this PRG works only
as 4 = ANI DNIS
This option defines the character
Telco uses as a delimiter (see
entries 1~5 in Program 34-09-01).
#
Valid entries are: 0~9, , and .
This option specifies the source of
the data the system uses to route
incoming ANI/DNIS calls. If option
'2' is selected, refer to Program 34-
09-04:
0 = Fixed Route (Item 08)
1 = Routes on Received DNIS or
Address Data
2 = Routes on Received ANI Data
Assigned Data
0 = 2nd Dial Tone
1 = Wink (default)
2 = Immediate
3 = Delay
(default = 2)
Related Programming
10-09
0 = DP
1 = DTMF
(default = 1)
0 = Specify Extension
Number (Intercom)
1 = Use Conversion
Table (NTT)
(default = 0)
0 = Disable (No)
1 = Enable (Yes)
(default = 1)
Day/Night Mode
1~8
Class: 1~15
(default = 1)
0 = Address
1 = ANI
2 = DNIS
3 = ANI Address
4 =
ANI DNIS
5 = DNIS ANI
(
= Delimiter Code)
(default = 0 for
COS 1~15)
#
1~9, 0, ,
(default = for
COS 1~15)
0 = Fixed Route (Item 08)
(No Routing)
1 = Routes on Received
DNIS or Address Data
2 = Routes on Received
ANI Data
(default = 0 for
COS 1~15)
Issue 1.0
Level
1 2 3
2 - 1075