NEC Univerge SV8100 Features And Specifications Manual page 1212

Issue 1.0
Program
Program Name
Number
14-05-01 Trunk Group – Trunk Group
Number
44-01-01 System Options for ARS/F-Route
– ARS/F-Route Time Schedule
44-02-01 Dial Analysis Table for ARS/
F-Route Access – Dial
44-02-02 Dial Analysis Table for ARS/
F-Route Access – Service Type
44-02-03 Dial Analysis Table for ARS/
F-Route Access – Additional Data
44-02-04 Dial Analysis Table for ARS/
F-Route Access – Dial Tone
Simulation
44-03-01 Dial Analysis Extension Table –
Dial
2 - 1188
Description/Comments
Assign trunks to trunk groups
(1~100).
Set this option to '0' so that the
F-Route table selected is
determined only by the digits dialed
without any relation to the day or
time of the call.
Set the number of digits to be
analyzed by the system for ARS
routing.
Select the Service Type (0 = No
Setting, 1 = Extension Call, 2 =
ARS/F-Route Table, 3 = Dial
Extension Analyze Table).
Enter the additional data required
for the service type selected in
Program 44-02-02, either the
number of digits to be deleted or
the table number to be used.
If enabled (1), this option sends dial
tone to the calling party once the
routing is determined. This may be
required if the central office at the
destination does not send dial tone.
Set the Dial digits (24 digits
#
maximum) 1~9, 0 , @) to be
used for the Dial Extension
Analysis Table. When Program 44-
02-02 is set to type "3", this
program sets the dial extension
analysis table. These tables are
used when the analyzed digits must
be more than eight digits. To enter
a wild card/don't care digit, press
Line Key 1 to enter an @ symbol.
UNIVERGE SV8100
Assigned Data
Trunk Group Number:
0~100 Priority Number:
1~200 (default = Trunk
Group 1, with priority in
ascending order.)
0 = Not Used
1 = Used
(default = 0)
Up to eight digits
(Use line key 1 for a
'Don't Care' digit, @)
(default not assigned)
0 = No Setting (None)
1 = Extension Call
(Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension
Analyze Table (Option)
(default = 0)
1 = Delete Digit = 0~255
(255 : Delete All Digits)
2 = 0~500
(0 = No Setting)
3 = Dial Extension
Analyze Table Number
= 0~4
(0 = No Setting)
(default = 0)
0 = Off
1 = On
(default = 0)
Up to 24 digits
Digits = 1~9, 0, , #, @
(Press Line Key 1 for
wild character @)
(default = Not assigned)
Uniform Numbering Network
Level
1 2 3