NEC Univerge SV8100 Features And Specifications Manual page 785

UNIVERGE SV8100
Program
Program Name
Number
80-04-09 Call Progress Tone Detector
Setup – OFF maximum time
81-11-01 Tie Line Initial Setup – DP
Interdigit Time Selection
81-11-02 Tie Line Initial Setup – Prepause
Time Selection
81-11-03 Tie Line Initial Setup – Tie Line
Answer Detect Time Selection
81-11-04 Tie Line Initial Setup – Tie Line
Release Detect Time Selection
81-11-05 Tie Line Initial Setup – Incoming
Signal Detect Time Selection
81-11-06 Tie Line Initial Setup – Loop
Off-Guard Time Selection
SV8100 Features and Specifications Manual
Description/Comments
Use to define the off maximum
time for the Call Progress Tone
Detector.
Select the DP Interdigit Time
(minimum pause time between
Dial Pulses).
Specify the loop open time for a
hookflash signal sent to the Tie
Line when the Recall key on a
multiline terminal is pressed. A
single line telephone generates a
hookflash to the Tie Line when a
single line telephone hookflash is
assigned.
Specify the time before a SV8100
System answer (off-hook) is
recognized as an answer.
Specify the before the circuit
disconnect detected on the Tie
Line on the distant system side is
recognized as Tie Line release.
Specify the time after the incoming
signal from another system is
detected before the acknowledge
signal is sent out.
Assign the loop off-guard time to
prevent noise that could cause the
system to be unable to answer an
incoming Tie Line.
Assigned Data
0~255 (30+30-7680ms)
default:
Type 1 (DT) – 1 (60ms)
Type 2 (BT) – 14
(450ms)
Type 3 (RBT) – 115
(3480ms)
Type 4, Type 5 – 0
0 = Pattern A
(Pattern A: 10pps – 650
ms,
20pps - 500 ms)
1 = Pattern B
(Pattern B: 10pps – 800
ms,
20pps - 800 ms)
(default = 1)
1~4
(1~4 = 0.5~2.0 seconds)
(5~15 = 3.0~13 seconds)
(0 = No Setting)
(default = 0)
0~15
(130 ms~1950 ms)
(0 = No Setting)
[default = 4 (520 ms)]
0~15
(130 ms~1950 ms)
(0 = No Setting)
[default = 4 (520 ms)]
[Wink Start]
1~15
(130 ms~1950 ms)
(0 = No Setting)
[Delay]
1~15
(30 ms~450 ms)
(0 = No Setting)
Default:
[Wink Start] 3 (390 ms)
[Delay] 3 (90 ms)
1~4
(0.5 sec~2.0 seconds)
5~15
(3 sec~13 seconds)
(0 = No Setting)
[default = 4 (2.0 ms)]
Issue 1.0
Level
1 2 3
2 - 761