NEC Univerge SV8100 Features And Specifications Manual page 635

Hide thumbs Also See for Univerge SV8100:
Table of Contents

Advertisement

UNIVERGE SV8100
Peer-to-Peer
An Ip telephone can send and receive RTP packets to/from another IP telephone without using the DSP
resources on the PZ-32IPLA, PZ-64IPLA or PZ-128IPLA. This operation only allows intercom calls
between the IP telephones.
If a DT700 Series IP multiline telephone, or trunk line is required, a DSP resource is needed and a
PZ-32IPLA, PZ-64IPLA or PZ-128IPLA must be installed. If, while on a peer-to-peer call, a conference call
is initiated, the peer-to-peer connection is released and a new non peer-to-peer connection is created
using the PZ-32IPLA, PZ-64IPLA or PZ-128IPLA. If the third party drops out of the conversation, the call
reverts to a peer-to-peer call (silence may be heard while this conversion is made by the system).
Although the peer-to-peer feature is supported for IP Station-to-IP Station calls, the UNIVERGE SV8100
chassis must still have a registered PZ-32IPLA, PZ-64IPLA or PZ-128IPLA installed in the system.
With Barge-In, a short silence may be heard if the following occurs:
A peer-to-peer call receives a Barge-In without a Barge-In tone.
A peer-to-peer call receives a Barge-In with Monitor mode.
When the established Barge-In is disconnected.
The peer-to-peer feature is a programmable feature that may be enabled or disabled (Program
10-26-01).
System Tones and Ring Tones
IP telephones do not use Program 80-01: Service Tone Setup entries. The tones are generated locally by
the IP telephone. When a Door Box chime rings an IP telephone, the system activates the chimes using a
ring command. Because of this, if the volume is adjusted while the door chime is sounding, the ringing
volume of the IP telephone will also be adjusted.
Music on Hold
Music on Hold is also provided by the IP telephone. The settings in Program 10-04: Music on Hold Setup
are ignored except to determine whether or not music should be provided. If Program 10-04-02 is set to 0,
no music on hold will be heard. If Program 10-04-02 is set to 1 or 2, music will be provided by the IP
telephone.
Registration Mode
The SV8100 has three types of registration for IP terminals, Plug and Play, Automatic, and Manual
programmed in 10-46-01:
Plug and Play mode – when the phone boots up it will report the extension assigned in the phoneor
choose the next available extension in the system. No password is required.
Automatic mode – the SIP user name and password must be entered into the actual IP phone. The
phone will come up as the extension associated with the user name and password entered.
SV8100 Features and Specifications Manual
Issue 1.0
2 - 611

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents