NEC Univerge SV8100 Features And Specifications Manual page 775

UNIVERGE SV8100
Program
Program Name
Number
14-01-02 Basic Trunk Data Setup –
Transmit Level
14-01-03 Basic Trunk Data Setup –
Receive Level
14-01-13 Basic Trunk Data Setup –
Trunk-to-Trunk Transfer
14-02-01 Analog Trunk Data Setup –
Signaling Type (DP/DTMF)
14-05-01 Trunk Group – Trunk Group
Number
14-06-01 Trunk Group Routing – Priority
Order Number
20-01-05 System Options – DTMF Receive
Active Time
20-06-01 Class of Service for Extensions
SV8100 Features and Specifications Manual
Description/Comments
Customize the transmit level of the
CODEC Gain for each trunk.
Customize the receive level of the
CODEC Gain for each trunk as
required.
Enable (1) loop supervision for
each Tie Line that should be able
to place outgoing calls.
Set the outgoing signaling type for
the tie trunk. The options are 0
(DP 10 pps), 1 (DP 20 pps) and 2
(DTMF). To set incoming
signaling, refer to Program
34-01-02.
Program Tie Lines of similar type
into the same trunk group. The
system uses trunk groups for
outgoing access to Tie Lines (i.e.,
Service Code 704 + group). Also
see Program 34-05-01.
Used to set the priority order
number 1~4.
After answering the Tie Line call,
the system attaches a DTMF
receiver to the Tie Line for this
interval (0~64800 seconds).
Assign a Class of Service (1~15)
to extensions.
Assigned Data
Trunks 1~200
1~63
(-15.5 ~ +15.5dB in
0.5dB intervals)
[default = 32 (0dB)]
Trunks 1~200
1~63
(-15.5 ~ +15.5dB in
0.5dB intervals)
[default = 32 (0dB)]
0 = Disable
1 = Enable
(default = 1)
0=Dial Pulse (10 PPS)
1=Dial Pulse (20 PPS)
2=DTMF
(default = 2)
Trunk Group Number:
0~100 Priority Number:
1~200
(default = Trunk Group 1,
with priority in ascending
order.)
0 = Not Specify1~100 :
(Trunk Group
Number)1001~1100 :
(1000 + Route Table
Number)
Default:
Route 1, Order Number
1 = 1 (Trunk Group 1)
Order Numbers 2, 3, 4 =
0 (Not Specified)
All Other Routes (2~100)
and Order Numbers
(1~4) = 0 (Not Specified).
0~64800 (seconds)
(default = 10 seconds)
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port =
Class 1
Issue 1.0
Level
1 2 3
2 - 751