NEC Univerge SV8100 Features And Specifications Manual page 1087

UNIVERGE SV8100
Setting handset ringer On/Off Volume in Standby Mode:
1. Press Vol key to adjust volume normal or high.
2. While Vol is pressed, the ringer starts to ring based on the current setting.
Ringer Volume can be adjusted with Ringer On/Off key in Off.
To Adjust Receiver Volume with a call in progress:
Press the Vol key repeatedly to adjust from Medium
When call is disconnected, default volume returns to Normal.
To Mute Handset to disable the microphone:
1. Press Mute key.
2. The Talk/Batt.low Led Blinks 500 msec On, 500msec Off during Mute.
3. Press Mute again to reactivate the microphone.
Voice is not transmitted during Mute.
To make a call with Auto Talk Off:
1. Lift the Handset from the Base Unit.
2. Press Talk key.
3. The Talk/Batt.low LED flashes then lights continuously to indicate an established communication
path between the Handset and the Base Unit and dial tone is generated.
4. Dial the number.
5. Talk to the party.
6. When finished, press the Talk key or place Handset back in the Base Unit to disconnect the call.
To make a call with Auto Talk On:
1. Lift the Handset from the Base Unit.
2. The Talk/Batt.low LED flashes then lights continuously to indicate established communication path
between the Handset and the Base Unit and dial tone is generated.
3. Dial the number.
4. Talk to the party.
5. When finished, press the Talk key or place Handset back in the Base Unit to disconnect the call.
To Hold a call in progress at the Base Unit:
1. Press Hold and return the Handset to the Base Unit.
2. To return to the held party press the flashing green line key and press Talk or pick up the Handset.
After a programmed time, the held call recalls to the originating terminal.
SV8100 Features and Specifications Manual
High Low Normal in this order.
Issue 1.0
2 - 1063