NEC Univerge SV8100 Features And Specifications Manual page 1139

UNIVERGE SV8100
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Program Name
Number
11-12-58 Service Code Setup (for Service
Access) – Transfer into
Conference
11-15-09 Service Code Setup
Administrative (for Special
Access) – Transfer to Incoming
Ring Group
15-02-05 Multiline Telephone Basic Data
Setup – Transfer Key Operation
Mode
15-02-24 Multiline Telephone Basic Data
Setup – Conference Key Mode
SV8100 Features and Specifications Manual
Description/Comments
Use this program to assign the
code users dial to Transfer a call
into a Conference call. This code is
normally 624.
When a call is transferred using this
service code, it is transferred to the
ring group destination for that
incoming trunk. For example, trunk
2 is in Ring Group 4. When the call
is transferred using this service
code, the trunk rings all extensions
programmed for Ring Group 4 or
ring the External Paging Group for
Ring Group 4, depending on how
the system is programmed.
Use this option to set the operating
mode of the extension Conf key.
The keys can be for Call Transfer
(0), Serial Calling (1) or Flash (2).
When selecting the Flash option,
refer also to Program 81-10-07 and
Program 81-10-08.
This option allows an extension
Conf key to be programmed for
Conference or for Transfer. When
set for Transfer (1), the user places
a call on hold, dials the extension to
which it should be transferred, the
presses the Conf key. The call is
then transferred. When set for
Conference (0), with an active call,
the user presses the Conf key,
places a second call, then presses
the Conf key twice. All the calls are
then connected.
Assigned Data
MLT, SLT
(default = 624)
(default not assigned)
0 = Transfer
1 = Call back
2 = Hook
(default = 0)
0 = Conference
1 = Transfer
(Default = 0)
Issue 1.0
Level
1 2 3
2 - 1115