NEC Univerge SV8100 Features And Specifications Manual page 632

Issue 1.0
Alarm Sensor Pattern
Operation
To place an Intercom call:
1. At multiline terminal, press Speaker.
- OR -
At single line telephone, lift the handset.
2. Dial extension number (or 9 for your operator).
Your call may voice-announce or ring the called extension. Dial 1 to change the way your call alerts the called
extension.
If the extension you call is busy or does not answer, you can dial another extension without hanging up.
To answer an Intercom call:
1. If you hear two beeps, speak toward telephone.
Your telephone picks up your voice.
- OR -
If your telephone rings, lift the handset.
To check the extension data (multiline terminal only):
1. Press the Help key.
2. Dial the extension number.
You display shows your telephone extension number, port number and extension/Department Group.
You can also check any other extension numbers information by pressing Help + the extension number.
3. Press Exit to return the normal time/date display.
To change how Intercom calls ring the extension:
1. Press Speaker or lift the handset.
2. Dial 723 to have calls ring your extension.
- OR -
3. Dial 721 to have calls voice announce to your extension.
2 - 608
Incoming Ring Tone
Number
Table 2-17 Incoming Ringing Tone
Tone
Type Frequency 1
High 760
Mid 760
Low 760
UNIVERGE SV8100
Frequency 2 Modulation
760 No Change
760 No Change
760 No Change
Intercom