Table 2-28 Keys For Entering Names - NEC Univerge SV8100 Features And Specifications Manual

UNIVERGE SV8100
4. Enter the name. (Refer to
Your name can be up to 12 digits maximum.
5. Press Hold.
6. Press Speaker to hang up.
To program any extension name:
1. Press Speaker.
2. Dial 700
- OR -
Press the Extension Name Change key (Program 15-07 or SC 751: 55).
3. Enter the extension number to be named.
4. Enter a name. (Refer to
The name can be have to 12 digits maximum.
5. Press Hold.
6. Press Speaker to hang up.
Use this keypad digit . . .
1
2
3
4
5
6
7
8
9
0
#
Conf
Hold
SV8100 Features and Specifications Manual
Table 2-21 Selectable Display Messaging Defaults on page
Table 2-28 Keys for Entering

Table 2-28 Keys for Entering Names

When you want to. . .
Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
Enter characters: A-C, a-c, 2.
Enter characters: D-F, d-f, 3.
Enter characters: G-I, g-i, 4.
Enter characters: J-L, j-l, 5.
Enter characters: M-O, m-o, 6.
Enter characters: P-S, p-s, 7.
Enter characters: T-V, t-v, 8.
Enter characters: W-Z, w-z, 9.
Enter characters:
0 ! " # $ %
Enter characters:
+ , - . /
# = Accepts an entry (only required if two letters on the same key are needed – ex:
TOM). Pressing # again = Space. (In system programming mode, use the right arrow
Softkey instead to accept and/or add a space.)
Clear the character entry one character at a time.
Clear all the entries from the point of the flashing cursor and to the right.
Names.).
←
Á À Â Ã
& ' ( ) ô Õ ú
: ; < = > ?
2-919.)
→
Ç É Ê ì ó
α ε θ β
å
ä ö ü
π Σ σ Ω
¢ £
Issue 1.0
2 - 995