Sflow Enable (Interface); Sflow Extended-Gateway Enable - Dell Force10 Z9000 Reference Manual

sflow enable (Interface)

Enable sFlow on Interfaces.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax sflow enable
To disable sFlow, use the no sflow enable command.
Defaults Disabled.
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.7.1.0
Version 7.6.1.0
Version 6.2.1.1
Usage When you enable sFlow on an interface, flow sampling is done on any traffic going out of the
Information interface.
Related sflow enable (Global)
Commands

sflow extended-gateway enable

Enable packing information on an extended gateway.
E-Series
Syntax sflow extended-gateway [extended-router] [extended-switch]
enable
To disable packing information, use the no sflow extended-gateway [extended-
router] [extended-switch] enable command.
Parameters
extended-router
1352
Introduced on the Z9000.
Introduced on the S4810.
Introduced on S-Series Stacking.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
NOTE: After a physical port is a member of a LAG, it inherits the sFlow configuration from
the LAG port.
– turns sFlow on globally.
Enter the keywords extended-router to collect extended router
information.