Debug Isis; Debug Isis Adj-Packets - Dell Z9500 Reference Manual

debug isis

Enable debugging for all IS-IS operations.
Z9500
Syntax
debug isis
To disable debugging of IS-IS, use the no debug isis command.
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.11.1
Usage
Entering debug isis enables all debugging parameters.
Information
To display all debugging information in one output, use this command. To turn off
debugging, you normally enter separate no forms of each command. To disable all
debug messages for IS-IS at once, enter the no debug isis command.

debug isis adj-packets

Enable debugging on adjacency-related activity such as hello packets that are sent and received on IS-IS
adjacencies.
Z9500
Syntax
debug isis [vrf vrf-name] adj-packets [interface]
To turn off debugging, use the no debug isis [vrf vrf-name]adj-packets
[interface] command.
Parameters
vrf vrf-name
Intermediate System to Intermediate System (IS-IS)
Description
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
(Optional) Enter the keyword vrf followed by the name of the
VRF to enable the debug information on IS-IS for an
1029