Crc - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

crc

crc { 16 | 32 | none }
Syntax
no crc
Command introduced before JUNOSe Release 7.1.0.
Release Information
Sets the size of the cyclic redundancy check. CRC is an error-checking technique that
Description
uses a calculated numeric value to detect errors in transmitted data. 16 and 32
indicate the number of check digits per frame that are used to calculate the FCS.
Both the sender and receiver must use the same setting. The default value is 16. The
no version restores the value to the default.
Options
Interface Configuration
Mode
470
crc
16 Specifies CRC-16, which transmits streams of 8-bit characters and generates
16-bit check bits per frame
32 Specifies CRC-32, which transmits longer streams at faster rates and
therefore provides better ongoing error detection
none Disables CRC checking