Goodrive350-19 Series VFD for Crane
Motor run
VFD 1
status
mechanis
is valid,
m run
P28.00=0
you can
modify
through the
PLC.
Note: For VFD 1, the master/slave control function code P28.00 needs to be modified through
the PLC. At the work conditions of cross travel mechanism run, if it is difficult to change VFD 1
from master/slave control mode to non master/slave control mode (P28.00=0) through the PLC,
you can set the hundreds place of P28.02 to 1 or use S terminal function 91 for VFD 1 to exit
the master/slave mode.
Parameters of VFD 2
Function
code
Function of S1
P05.01
Hoisting application
P90.00
macro setting
Terminal-switched
application macro
P90.01
Method for terminals to
switch application
P90.03
Master/slave mode
A81.24
5.5.5 User-defined application macros
You can enter user-defined application macro settings through P90.02.
Function
code
User-defined
P90.02
application macro
VFD 2
valid, A82.24=0
(P28.00=0), you
can switch
through S1.
Name
35: Switch from motor 1 to motor 2
6: User-defined application macro 1
7: User-defined application macro 2
setting
1: Switch from motor 1 to motor 2
macros
2: The local device is the slave.
Name
0–3
0: None
1: Enter the settings of user-defined application
macro 1
2: Enter the settings of user-defined application
setting
macro 2
3: Enter the settings of user-defined application
macro 3
VFD 2
KM1 KM2
Terminal
S1
Description
Description
-119-
Commissioning guidelines
Cross
Lifting
Lifting
travel
motor
motor
mechanis
1
2
m motor
switch
through
Setting
Default
S1.
35
6
7
1
2
0
Need help?
Do you have a question about the Goodrive350-19 Series and is the answer not in the manual?