INVT Goodrive350-19 Series Operation Manual page 228

Goodrive350-19 Series VFD for Crane
Function
Name
code
P10.36 PLC restart mode
P10.37 Multi-step time unit
Description
BIT7 BIT6
BIT9 BIT8
BIT11 BIT10
BIT13 BIT12
BIT15 BIT14
BIT1 BIT0
BIT3 BIT2
BIT5 BIT4 10
BIT7 BIT6 11
P10.35
BIT9 BIT8 12
BIT11 BIT10 13
BIT13 BIT12 14
BIT15 BIT14 15
Select corresponding acceleration/deceleration
time, and then convert 16-bit binary number
into hexadecimal number, finally, and then set
corresponding function codes.
ACC/DEC time 1 is set by P00.11 and P00.12;
ACC/DEC time 2 is set by P08.00 and P08.01;
ACC/DEC time 3 is set by P08.02 and P08.03;
ACC/DEC time 4 is set by P08.04 and P08.05.
Setting range: 0x0000–0xFFFF
0: Restart from the first step, namely if the VFD
stops during running
command, fault or power down), it will run from
the first step after restart.
1: Continue running from the step frequency
when interruption occurred, namely if the VFD
stops during running (caused by stop command
or fault), it will record the running time of current
step, and enters this step automatically after
restart, then continue running at the frequency
defined by this step in the remaining time.
0: second; the running time of each step is
counted in seconds
1: minute; the running time of each step is
-216-
3 00 01 10
4 00 01 10
5 00 01 10
6 00 01 10
7 00 01 10
8 00 01 10
9 00 01 10
00 01 10
00 01 10
00 01 10
00 01 10
00 01 10
00 01 10
(caused by
Function parameters
Default Modify
11
11
11
11
11
11
11
11
11
11
11
11
11
stop
◎
0
◎
0