INVT Goodrive350-19 Series Operation Manual page 496

Goodrive350-19 Series VFD for Crane
D.3.1.3 Displaying fault information
The VFD enters fault alarm display state once fault signal is detected, and the keypad displays fault
code and fault information with TRIP indicator on the keypad turning on. You can perform fault reset
by using the STOP/RST key, control terminals, or communication commands.
If the fault persists, the fault code is continuously displayed.
D.3.2 Operating the VFD through the LCD keypad
Various operations can be performed on the VFD, including entering/exiting menu, parameter
selection, list modification and parameter addition.
D.3.2.1 Entering/Exiting menus
The keypad displays three main menus at the home interface by default: Parameter, About, and
Menu. The following figure shows how to enter the Parameter main menu and how to operate under
this main menu.
16:02:35 Fwd Local Ready
Set Freq
50.00
P17.00 Hz
DC Bus Volt
540.0
P17.11 V
HDIB/A/S4/3/2/1
000000
P17.12
Parameter About
16:02:35
Fwd
Type of present fault:
Fault code：
19：Current detection fault (ItE)
Return
Figure D-7 Fault alarm display
16:02:35
GD350-19
Function group:
P00: Basic Function
Back
Menu
Figure D-8 Entering/exiting the parameter menu
Local Fault GD350-19
19
Homepage
Fwd Local Ready GD350-19
P00
Home Sele
-484-
Optional peripheral accessories
Conf
16:02:35 Fwd Local
Function code:
P00.00: Speed Ctrl Run Cmd
Back
Ready GD350-19
P00.00
Home Sele