INVT Goodrive350-19 Series Operation Manual page 503

Goodrive350-19 Series VFD for Crane
16:02:35 Fwd
Local Ready
P17.01：OutpFreq
P17.00：Set Freq
P17.11：DC Bus Volt
P17.03：Outp Volt
P17.04：Outp Cur
P17.05：Motor Speed
Back Add
16:02:35
Fwd Local Ready
P17.01：OutpFreq
P17.00：Set Freq
P17.11：DC Bus Volt
P17.03：Outp Volt
P17.04：Outp Cur
P17.05：Motor Speed
Back Add
After selecting a specific function code, press
press key,
included in the list of parameters displayed in stopped state or list of parameters displayed in running
state, the parameter added will be at the end of the list; if the parameter is already in the list of
parameters displayed in stopped state or list of parameters displayed in running state, the addition
operation will be invalid. If
"Addition" interface, it will return to monitoring parameter list menu.
Part of the monitoring parameters in P07 HMI group can be added to the "parameter displayed in stop
state" list or "parameter displayed in running state" list; all the parameters in P17, P18 and P19 group
can be added to the "parameter displayed in stop state" list or "parameter displayed in running state"
list.
Up to 16 monitoring parameters can be added to the list of parameters displayed in stopped state;
and up to 32 monitoring parameters can be added to the list of parameters displayed in running state.
D.3.2.4 Adding parameters to the user defined parameter setting list
You can choose Menu > Parameter groups, choose a submenu, and enter a specific function group
and then a specific function code to add the parameter to the user defined parameter list.
16:02:35 Forward
P01.00：StartRun Mode
P01.01：DirectStart Freq
P01.02：StartFreq HoldTime
P01.03：Prestart BrakeCur
P01.04：Prestart BrakeTime
P01.05：Acc/Dec Mode
Back
16:02:35
GD350-19
Stopped-state parameters
Running-state parameters
OK Back
16:02:35
GD350-19
Stopped-state parameters
Running-state parameters
OK Back
Figure D-13 Adding parameters 1
key or key to confirm the addition operation. If this parameter is not
key or
Local Ready GD350-19
Add Sele
Figure D-14 Adding parameters 2
Fwd
Local Ready GD350-19
Home Sele
Fwd
Local Ready GD350-19
Home Sele
key to enter parameter addition interface, and
key is pressed without selecting addition operation in
16:02:35
Back
-491-
Optional peripheral accessories
16:02:35 Fwd
Sure to add to Stopped-state
parameters?
Back
16:02:35 Fwd
Sure to add to Running-state
parameters?
Back
Forward Local Ready GD350-19
Sure to add to user defined
parameters?
Home OK
Local Ready GD350-19
Home OK
Local Ready GD350-19
Home OK