Goodrive350-19 Series VFD for Crane
Fault
Fault type
code
[63] Communication
C1-Er
timeout of expansion
card at card slot 1
[64] Communication
C2-Er
timeout of expansion
card at card slot 2
[65] Communication
C3-Er
timeout of expansion
card at card slot 3
[66] EtherCAT card
E-CAT
communication
timeout fault
[67] BACnet card
E-BAC
communication
timeout fault
Possible cause
There is no data
transmission in interface at
card slot 1.
There is no data
transmission in interface at
card slot 2.
There is no data
transmission in interface at
card slot 3.
No data transmission
between the communication
card and the host controller
(or PLC).
No data transmission
between the communication
card and the host controller
-355-
Troubleshooting
Solution
check whether the fault persists
at next power-on.
Check whether the insertion port
is damaged. If yes, replace the
insertion port after power-off.
Confirm whether the expansion
card inserted can be supported.
Stabilize the expansion card
interfaces after power-off, and
check whether the fault persists
at next power-on.
Check whether the insertion port
is damaged. If yes, replace the
insertion port after power-off.
Confirm whether the expansion
card inserted can be supported.
Stabilize the expansion card
interfaces after power-off, and
check whether the fault persists
at next power-on.
Check whether the insertion port
is damaged. If yes, replace the
insertion port after power-off.
Confirm whether the expansion
card inserted can be supported.
Stabilize the expansion card
interfaces after power-off, and
check whether the fault persists
at next power-on.
Check whether the insertion port
is damaged. If yes, replace the
insertion port after power-off.
Check whether the
communication card wiring is
loose or dropped.
Check whether the
communication card wiring is
loose or dropped.
Need help?
Do you have a question about the Goodrive350-19 Series and is the answer not in the manual?