INVT Goodrive350-19 Series Operation Manual page 214

Goodrive350-19 Series VFD for Crane
Function
Name
code
Frequency
P08.30 decrease ratio in
droop control
Channel switching
P08.31 for motor 1 to motor
FDT1 electrical
P08.32 level detection
value
FDT1 lagging
P08.33
detection value
FDT2 electrical
P08.34 level detection
value
FDT2 lagging
P08.35
detection value
Setting range of P08.28: 0–10
Setting range of P08.29: 0.1–3600.0s
The output frequency of the VFD changes as
the load changes. The function code is mainly
used to balance the power when several
motors drive a same load.
Setting range: 0.00–50.00Hz
0x00–0x15
Ones place: Switchover channel
0: Switch over through terminals
1: Modbus/Modbus TCP communication
2: PROFIBUS/CANopen/DeviceNet
communication
3: Ethernet communication
4: EtherCAT/PROFINET/EtherNet IP
3
communication
5: Reserved
Tens place: indicates whether to enable
switchover during running
0: Disable
1: Enable
When the output frequency exceeds the
corresponding frequency of FDT electrical level,
the multifunction digital output terminal
continuously outputs the signal of "Frequency
level detection FDT". The signal is invalid only
when the output frequency decreases to a
value lower than the frequency corresponding
to (FDT electrical level—FDT lagging detection
value).
FDT level
Y1,
RO1, RO2
Setting range of P08.32: 0.00Hz–P00.03 (Max.
output frequency)
Description
Output frequency f
FDT lag
Time t
-202-
Function parameters
Default Modify
0.00Hz
0x00
50.00Hz
5.0%
50.00Hz
5.0%
Time t
○
◎
○
○
○
○