Goodrive350-19 Series VFD for Crane
Function
Name
code
Detected load
P94.01
torque value
Brake detection
P94.02
reminding time
Actual step of
P94.03
graded multi-step
speed
Zero-point position
P94.04
status
P94.05
Measured height
High bits of height
P94.06
measuring pulse
count value
Low bits of height
P94.07
measuring pulse
count value
Upper limit of
P94.08
PT100 calibration
temperature
Description
15: Weighing alarm (A-OvL)
16:
Alarm
of
slave
master/slave control (A-SLO)
17: Alarm of automatic brake detection at
power-on (A-bEt)
18: Alarm indicating the set frequency is less
than the brake closing frequency after brake
release (A-rSF)
19: Brake detection light-wear alarm (A-LbE)
20: Brake detection heavy-wear alarm (A-obE)
21: Tower crane lifting top-hitting alarm (A-PSP)
0.0% –150.0% (of the motor rated torque)
0.0–1000.0h
0–6
0–2
0: There is input at zero-point position, but the
VFD is still in running state.
1: The VFD has stopped, but there is input of
zero-point signal, and zero position delay is
reached (zero position is valid).
2: In condition of status 1, if a run command is
given and the zero position has been left, the
run command is effective.
0.00–655.35m (hook lowering distance)
(As the master in master/slave control, it sends
this value.)
0–65535
0–65535
-20.0–150.0° C
-344-
brake
feedback
in
Function parameters
Default Modify
●
0.0%
●
0.0h
●
0
●
0
●
0.00
●
0
●
0
●
0.0° C
Need help?
Do you have a question about the Goodrive350-19 Series and is the answer not in the manual?