R&S ESU Series Operating Manual page 92

R&S ESU
DELETE The DELETE RANGE softkey clears the activated scan range. All other ranges are
RANGE shifted to the left by one column.
Remote command:
RANGES With the RANGES 1-5 | 6-10 softkey a switchover can be made between ranges 1-5
1-5 | 6-10 and 6-10.
Remote command:
FREQ AXIS For details refer to
LIN | LOG
10dB MIN For details refer to
ON | OFF
RUN PRE- For details refer to
SCAN+FINAL
RUN SCAN For details refer to
USE CURR
The USE CURR SETTINGS softkey activates a scan which is performed using the
SETTINGS current receiver settings. The step size is automatically set with respect to the IF
bandwidth (Step Mode Auto). The start and stop frequency is set via the FRE-
QUENCY menu.
Remote command:
FIXED The FIXED FREQUENCY softkey activates time domain analysis.
FREQUENCY
The overall measurement time for time domain analysis can be defined in a data
entry field. The range is 10 µs to 10.000 s. The value entered is rounded to next inte-
ger that is a multiple of the measurement time of a single bar graph measurement.
The minimum value also depends on the set measurement time of a single bar
graph measurement and is at least twice this value.
Remote command:
SINGLE SCAN Pressing the SINGLE SCAN softkey triggers a frequency scan. R&S ESU stops at
the end frequency.
The enhancement label SGL displayed at the screen edge indicates that the single-
scan mode is set.
Remote command:
CONTINUOUS The CONTINUOUS SCAN softkey selects the continuous scan mode. R&S ESU
SCAN scans continuously until the scan is stopped.
Remote command:
FREQ AXIS The FREQ AXIS LIN | LOG switches between linear and logarithmic frequency axis.
LIN | LOG
Default is LOG.
Remote command:
Operating Manual 1302.6163.12 - 03
--
--
"FREQ AXIS LIN | LOG" on page
"10 DB MIN ON | OFF" on page 4.18
"Triggering the Scan – TRIG Key" on page
"RUN SCAN" on page 4.62.
--
FREQ:MODE CW
SCAN:TDOMain 100 s
:INIT2:CONT OFF
:INIT2:CONT ON
DISP:TRAC:X:SPAC LOG
Instrument Functions
Receiver Mode
4.61.
(AMPT menu).
4.63.
4.61