R&S ESU Series Operating Manual page 46

R&S ESU
STEPSIZE = The STEPSIZE = FREQ softkey sets the step size to a value equal to the receive
FREQ frequency.
This function is especially useful during measurements of the signal harmonic con-
tent, because, when entering the receiver frequency, the receiver frequency of
another harmonic is selected with each stroke of the STEP key.
Remote command:
START The START softkey opens a window where the start frequency of the scan diagram
can be entered.
The permissible value range for the start frequency is:
Remote command:
STOP
The STOP softkey opens a window where the stop frequency of the scan diagram
can be entered.
Remote command:
RUN PRE-
For details refer to the SWEEP menu,
SCAN+FINAL
RUN SCAN For details refer to the SWEEP menu,
Operating Manual 1302.6163.12 - 03
≤ f ≤ f
f – 10 Hz
min start max
f : start frequency
start
f : maximum frequency
max
--
:FREQ:STAR 20 MHz
:FREQ:STOP 2000 MHz
"RUN PRE-SCAN+FINAL" on page
"RUN SCAN" on page
Instrument Functions
Receiver Mode
4.62.
4.62.
4.15