R&S ESU Series Operating Manual page 543

R&S ESU
6.8 DISPlay Subsystem
The DISPLay subsystem controls the selection and presentation of textual and graphic information as
well as of measurement data on the display.
The measurement windows are selected by WINDow1 (screen A) or WINDow2 (screen B).
DISPlay:FORMat SINGle | SPLit
This command switches the measurement result display between FULL SCREEN and SPLIT
SCREEN. The coupling of settings between screen A and screen B can be selected with the command
INSTrument:COUPle.
In full-screen display the active measurement window can be selected with DISPlay:WINDow<1|2>:
SELect.
Example:
"DISP:FORM SPL"
'Switches the display to 2 measurement windows.
Characteristics: *RST value: SINGle
SCPI: device-specific
Mode: R, A
DISPlay:ANNotation:FREQuency ON | OFF
This command switches the x-axis annotation on or off.
Example:
"DISP:ANN:FREQ OFF"
Characteristics: *RST value: ON
SCPI: conform
Mode: R, A
DISPlay:LOGO ON | OFF
This command switches the company logo on the screen on or off.
Example:
"DISP:LOGO OFF"
Characteristics: *RST value: ON
SCPI: device-specific
Mode: R, A
DISPlay:PSAVe[:STATe] ON | OFF
This command switches on or off the power-save mode of the display. With the power-save mode
activated the display including backlight is completely switched off after the elapse of the response
time (see command DISPlay:PSAVe:HOLDoff).
This mode is recommended for preserving the display especially if the instrument
is exclusively operated via remote control.
Example:
"DISP:PSAVe ON"
'Switches on the power-save mode.
6.104
Remote Control – Description of Commands
Operating Manual 1302.6163.12 - 03
DISPlay Subsystem