R&S ESU
This low average value is usually corrected in noise power measurements by a 2.5
dB factor. Therefore the R&S ESU offers the selection of linear averaging. The trace
data are delogarithmized prior to averaging, then averaged and logarithmized again
for display on the screen. The average value is always correctly displayed
irrespective of the signal characteristic.
COPY TRACE
The COPY TRACE softkey copies the screen contents of the current trace into
another trace memory. The desired memory is selected by entering the number 1, 2
or 3.
Upon copying, the contents of the selected memory are overwritten and the new
contents displayed in view mode.
Remote command:
4.94
TRAC:COPY TRACE1,TRACE2
Operating Manual 1302.6163.12 - 03
Instrument Functions
IF Spectrum Analysis Mode