R&S ESU Series Operating Manual page 625

R&S ESU
"SENSe:LIST:POWer
performs a measurement sequence with the following settings:
Step Freq. Ref Level
[MHz]
1 935.2 -20 dBm
2 935.4 -20 dBm
3 935.6 -20 dBm
"SENSe:LIST:POWer?
performs the same measurement and returns the result list immediately after the last frequency point.
• The measurement is performed in the time domain and therefore the span is set
to 0 Hz. If the time domain is abandoned, the function is automatically switched
off.
• The measurement is not compatible with other measurements, especially as far
as marker, adjacent channel power measurement or statistics are concerned.
The corresponding commands thus automatically deactivate the function.
• The function is only available in remote control. It is deactivated when switching
the instrument back to LOCAL.
Characteristics: *RST value: --
SCPI: device-specific
Mode: A
6.186
935.2MHz,-20dBm,10dB,OFF,NORM,1MHz,3MHz,434us,0,
935.4MHz,-20dBm,10dB,OFF,CFIL,30kHz,100kHz,434us,0,
935.6MHz,-20dBm,10dB,OFF,CFIL,30kHz,100kHz,434us,0"
RF Att el Att Filter type
10 dB OFF Normal
10 dB OFF Channel
10 dB OFF Channel
935.2MHz,-20dBm,10dB,OFF,NORM,1MHz,3MHz,434us,0,
935.4MHz,-20dBm,10dB,OFF,CFIL,30kHz,100kHz,434us,0,
935.6MHz,-20dBm,10dB,OFF,CFIL,30kHz,100kHz,434us,0"
Remote Control – Description of Commands
RBW VBW Meas Time
1 MHz 3 MHz 434 us
30 kHz 100 kHz 434 us
30 kHz 100 kHz 434 us
Operating Manual 1302.6163.12 - 03
SENSe Subsystem
TRG Level
(reserved)
0
0
0