R&S ESU Series Operating Manual page 78

R&S ESU
Fig. 4.18 Results of prescan and final measurement
Automatic Control of Line Impedance Stabilization Networks
The selected phases are controlled during the prescan and the final measurement
via the USERPORT with the LISN switched on.
Only one phase and one PE setting (1 out of n) can be selected for the prescan. Any
number of settings can be selected for the final measurement (m out of n).
All selected phase/PE combinations are measured during the final measurement
and the maximum value is determined.
The softkeys to select the V-network to be controlled in the PRESCAN PHASES and
in the FINAL PHASES are available either via the side menu of the
submenu or via the side menu of the
In contrast, the LISN menu in the SETUP menu is used for the direct control of the
LISN and is not included in the automatic sequences.
Operating Manual 1302.6163.12 - 03
THRESHOLD SCAN submenu.
Instrument Functions
Receiver Mode
FINAL MEAS
4.47