R&S ESU Series Operating Manual page 638

R&S ESU
Characteristics: *RST value:
40 kHz (ALT1)
60 kHz (ALT2)
80 kHz (ALT3)
100 kHz (ALT4)
120 kHz (ALT5)
140 kHz (ALT6)
160 kHz (ALT7)
180 kHz (ALT8)
200 kHz (ALT9)
220 kHz (ALT10)
240 kHz (ALT11)
SCPI: device-specific
Mode: A-F
[SENSe<1|2>:]POWer:ACHannel:TXCHannel:COUNt 1 to 12
This command selects the number of carrier signals.
The command is available only for multi carrier channel and adjacent channel power measurements
(CALC:MARK:FUNC:POW:SEL MCAC) in the frequency domain (span > 0).
Example:
"POW:ACH:TXCH:COUN 3"
Characteristics: *RST value: 4
SCPI: device-specific
Mode: A-F
[SENSe<1|2>:]POWer:ACHannel:ACPairs 0 to 12
This command sets the number of adjacent channels (upper and lower channel in pairs). The figure 0
stands for pure channel power measurement.
The command is only available in the frequency domain (span > 0).
Example:
"POW:ACH:ACP 3"
'Sets the number of adjacent channels to 3, i.e. the adjacent channel and alternate
adjacent channels 1 and 2 are switched on.
Characteristics: *RST value: 1
SCPI: device-specific
Mode: A-F
[SENSe<1|2>:]POWer:ACHannel:BANDwidth|BWIDth[:CHANnel] 100 Hz to 1000 MHz
This command sets the channel bandwidth of the radio communication system. The bandwidths of
adjacent channels are not influenced by this modification (in contrast to the FSE family).
With SENS:POW:HSP ON the steep-edged channel filters from the table "List of available channel
filters" in chapter "Instrument
on page 4.111 are available.
Example:
"POW:ACH:BWID 30kHz"
'Sets the bandwidth of the TX channel to 30 kHz.
Characteristics: *RST value: 14 kHz
SCPI: device-specific
Operating Manual 1302.6163.12 - 03
Functions", section "Setting the Bandwidths and Sweep Time – BW Key"
Remote Control – Description of Commands
SENSe Subsystem
6.199