R&S ESU Series Operating Manual page 682

R&S ESU
SYSTem:KLOCk ON | OFF
The alias remote command SYST:KLOC can be used to activate the LLO (local lockout) or to return to
the local mode (GTL go to local). Parameter ON is LLO, OFF is GTL.
Example:
"SYST:KLOC ON"
'activates LLO
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
SYSTem:LANGuage <language>
This command activates the emulation of various analyzers. The analyzer default command set is
SCPI.
The following remote-control languages are available:
SCPI, 71100C, 71200C, 71209A, 8560E, 8561E, 8562E, 8563E, 8564E, 8565E, 8566A, 8566B,
8568A, 8568A_DC, 8568B, 8568B_DC, 8591E, 8594E
•
•
•
The settings or changes made on switching between remote-control languages are described in the
Quick Start Guide, chapter 2.
Notes regarding switch over to 8566A/B and 8568A/B:
•
•
•
Example:
"SYST:LANG 'SCPI'"
Characteristics: *RST value: 'SCPI'
SCPI: conform
Mode: R, A
There is no query for this command.
Operating Manual 1302.6163.12 - 03
When SCPI is selected, the 8566B/8568B/8594E command set is available in
addition.
When 8566A, 8566B, 8568A or 8568B is selected, both command sets A and B
are available, as far as they are supported.
The HP model 8591E is compatible to HP model 8594E,
the HP models 71100C, 71200C, and 71209A are compatible to HP models
8566A/B.
Commands IP and KST, too, will perform the settings for the "# of Trace Points",
"Start Freq.", "Stop Freq." and "Input Coupling".
Switch over of the "# of Trace Points" will not take place until the instrument is
switched to the remote control mode. For manual operation (selected with
LOCAL softkey), the number of sweep points (trace points) will always be set to
1251.
In the remote control mode, the screen area for the measurement will be
reduced. The LOCAL softkey (lowermost softkey) will be shifted slightly towards
the center of the screen.
Remote Control – Description of Commands
SYSTem Subsystem
6.243