R&S ESU Series Operating Manual page 312

R&S ESU
The following instrument settings will then be changed:
Model
8566A/B
8568A/B
8560E
8561E
8562E
8563E
8564E
8565E
8594E
Notes regarding switch over to 8566A/B and 8568A/B on R&S FSUP
• The stop frequency indicated in the table may be limited to the corresponding
frequency of the R&S ESU, if required.
Remote command:
IF GAIN NORM/ The IF GAIN NORM/PULS softkey configures the internal IF gain settings in HP
PULS emulation mode due to the application needs. This setting is only taken into account
for resolution bandwidth < 300 kHz.
NORM
PULS
This softkey is only available, if a HP languge is selected via the
softkey.
Remote command:
SWEEP REP The SWEEP REP ON/OFF softkey controls a repeated sweep of the E1 and MKPK
ON/OFF HI HP model commands (for details on the commands refer to
HP Models 856xE, 8566A/B, 8568A/B and 8594E" on page
sweep is OFF, the marker is set without sweeping before.
In single sweep mode, switch off this softkey before you set the marker via the E1
and MKPK HI commands in order to avoid sweeping afresh.
Operating Manual 1302.6163.12 - 03
# of Trace Start Freq.
Points
1001 2 GHz
1001 0 Hz
601 0 Hz
601 0 Hz
601 0 Hz
601 0 Hz
601 0 Hz
601 0 Hz
401 0 Hz
SYST:LANG "SCPI" | "8560E" |
"8561E" | "8562E" | "8563E" |
"8564E" | "8565E" | "8566A" |
"8566B" | "8568A" | "8568A_DC" |
"8568B" | "8568B_DC" | "8591E" |
"8594E" | "71100C" | "71200C" |
"71209A"
Optimized for high dynamic range,
overload limit is close to reference level.
Optimized for pulsed signals,
overload limit up to 10 dB above reference level.
SYST:IFG:MODE PULS
Stop Freq. Ref Level
22 GHz 0 dBm
1.5 GHz 0 dBm
2.9 GHz 0 dBm
6.5 GHz 0 dBm
13.2 GHz 0 dBm
26.5 GHz 0 dBm
40 GHz 0 dBm
50 GHz 0 dBm
3 GHz 0 dBm
6.263). If the repeated
Instrument Functions
Basic Settings
Input
Coupling
DC
AC
AC
AC
AC
AC
AC
AC
AC
GPIB LANGUAGE
"GPIB Commands of
4.281