R&S ESU Series Operating Manual page 611

R&S ESU
[SENSe<1|2>:]ESPectrum:RANGe<1...20>[:FREQuency]:STOP <numeric_value>
This command sets the relative stop frequency of a range in the Spectrum Emission Mask
measurement.
The numeric suffixes <1...20> specify the range. The numeric suffix at SENSe<1|2> is irrelevant.
Example:
"ESP:RANG2:STOP 2.52MHZ"
'stop frequency of range 2 to +2.52MHz
Characteristics: *RST value:-
SCPI: device-specific
Mode: A
[SENSe<1|2>:]ESPectrum:RANGe<1...20>:INPut:ATTenuation <numeric_value>
This command defines the RF attenuation of a range in the Spectrum Emission Mask measurement.
The numeric suffixes <1...20> specify the range. The numeric suffix at SENSe<1|2> is irrelevant.
Example: "ESP:RANG2:INP:ATT 30db"
'RF attenuation of range 2 to 30 dB
Characteristics: *RST value:-
SCPI: device-specific
Mode: A
[SENSe<1|2>:]ESPectrum:RANGe<1...20>:INPut:ATTenuation:AUTO ON | OFF
This command switches the attenuation mode of a range in the Spectrum Emission Mask
measurement to AUTO (ON) or MANUAL (OFF).
The numeric suffixes <1...20> specify the range. The numeric suffix at SENSe<1|2> is irrelevant.
Example:
"ESP:RANG2:INP:ATT:AUTO ON"
'attenuation mode is AUTO for range 2
Characteristics: *RST value: ON
SCPI: device-specific
Mode: A
[SENSe<1|2>:]ESPectrum:RANGe<1...20>:INPut:GAIN:STATe ON | OFF
This command switches the preamplifier of a range in the Spectrum Emission Mask measurement on
or off.
The numeric suffixes <1...20> specify the range. The numeric suffix at SENSe<1|2> is irrelevant.
Example:
"ESP:RANG2:INP:GAIN:STAT ON"
' activates the preamplifier for range 2
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
6.172
Remote Control – Description of Commands
Operating Manual 1302.6163.12 - 03
SENSe Subsystem