Introduction - R&S ESU Series Operating Manual

R&S ESU

4.1 Introduction

All functions of the R&S ESU and their application are explained in detail in this
chapter. The sequence of the described menu groups depends on the procedure
selected for the configuration and start of a measurement:
1. Resetting the instrument
–
2. Setting the mode
–
–
3. Setting the measurement parameters in receiver mode
–
4. Setting the measurement parameters in IF analyzer mode
–
5. Setting the measurement parameters in APD mode
–
6. Setting the measurement parameters in analyzer mode
–
7. Basic functions for general settings, printout and data management
–
–
–
–
–
8. Additional and optional functions
–
–
–
–
The operating concept is described in the Quick Start Guide, chapter 4, "Basic Oper-
ation".
The remote commands (if any) are indicated for each softkey. A detailed description
of the associated remote commands is given in chapter
tion of
Operating Manual 1302.6163.12 - 03
"R&S ESU Initial Configuration – PRESET Key" on page 4.6
"Mode Selection – Hotkey Bar" on page 4.9
"Return to Manual Operation – LOCAL Menu" on page 4.10
"Receiver Mode" on page 4.11
"IF Spectrum Analysis Mode" on page 4.77
"APD Mode" on page 4.95
"Analyzer Mode" on page 4.102
"Setup of Limit Lines and Display Lines – LINES Key" on page 4.240
"Configuration of Screen Display – DISP Key" on page 4.252
"Instrument Setup and Interface Configuration – SETUP Key" on page 4.260
"Saving and Recalling Data Sets – FILE Key" on page 4.299
"Measurement Documentation – HCOPY Key" on page 4.307
"Tracking Generator – Option R&S FSP-B9" on page 4.217
"External Generator Control – Option R&S FSP-B10" on page 4.333
"LAN Interface - Option R&S FSP-B16" on page 4.352
"User Port" on page 4.372
Commands".
Instrument Functions
Introduction
"Remote Control – Descrip-
4.5