R&S ESU Series Operating Manual page 757

R&S ESU
Differences in GPIB Behavior between the FSP and the FSE Families of Instruments
Devices Command (Sheet 30 of 47)
FSE [SENSe<1|2>:]AVERage:AUTO
R&S FSE [SENSe<1|2>:]AVERage:COUNt
ESU
FSE [SENSe<1|2>:]AVERage:COUNt
R&S [SENSe<1|2>:]AVERage:TYPE
ESU
FSE [SENSe<1|2>:]AVERage:TYPE
R&S FSE [SENSe<1|2>:]AVERage[:STATe<1...3>]
ESU
FSE [SENSe<1|2>:]BANDwidth|BWIDth:DEMod
FSE [SENSe<1|2>:]BANDwidth|BWIDth:PLL
R&S FSE [SENSe<1|2>:]BANDwidth|BWIDth:VIDeo
ESU
FSET [SENSe<1|2>:]BANDwidth|BWIDth:VIDeo
R&S FSE [SENSe<1|2>:]BANDwidth|BWIDth:VIDeo:AUTO
ESU
FSET [SENSe<1|2>:]BANDwidth|BWIDth:VIDeo:
EXTernal[:STATe]
R&S [SENSe<1|2>:]BANDwidth|BWIDth:VIDeo:RATio
ESU
FSE [SENSe<1|2>:]BANDwidth|BWIDth:VIDeo:RATio
R&S FSE [SENSe<1|2>:]BANDwidth|BWIDth[:RESolution]
ESU
FSET [SENSe<1|2>:]BANDwidth|BWIDth[:RESolution]
R&S FSE [SENSe<1|2>:]BANDwidth|BWIDth[:RESolution]:
ESU AUTO
FSE [SENSe<1|2>:]BANDwidth|BWIDth[:RESolution]:
MODE
6.318
Remote Control – Description of Commands
Parameter Notes
ON | OFF not available for
R&S ESU
0 to 32767
0 to 32767
VIDeo | LINear command is used to
select logarithmic or
linear averaging on the
R&S ESU;
therefore parameters are
incompatible to the FSE
MAXimum | MINimum | command is used to
SCALar select logarithmic or
linear averaging on the
R&S ESU;
therefore parameters are
incompatible to the FSE
ON | OFF
<numeric_value> not available for
R&S ESU and FSET
AUTO | HIGH | MEDium not available for
| LOW R&S ESU
1Hz to 10MHz
1Hz to 500MHz
ON | OFF
ON | OFF not available for
R&S ESU
0.0001 to 1 only numeric values
available. Parameter
ranges differ between
R&S ESU and FSE
0.001 to 1000 | SINe | also text parameters are
PULSe | NOISe available. Parameter
ranges differ between
R&S ESU and FSE
not available for FSET
10Hz to 10MHz (anal. FSE: 10Hz to 10MHz
filter) 1Hz to 10MHz (models 20) 1Hz to
(FFT filter) 10MHz (models 30)
10 Hz to 500MHz
ON | OFF
ANALog | DIGital not available for
R&S ESU and FSET
Operating Manual 1302.6163.12 - 03