R&S ESU Series Operating Manual page 603

R&S ESU
[SENSe<1|2>:]CORRection:TSET:BREak ON | OFF
This command defines if the sweep is to be stopped on changeover from range to another. Prior to this
command, the command SENS:CORR:TSET:SEL must be sent.
Example:
"CORR:TSET:SEL 'SET1'"
"CORR:TSET:BRE ON"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: R, A
[SENSe<1|2>:]CORRection:TSET:CATalog?
This command reads out the names of all transducer sets stored on the internal drive.
Syntax of output format:
<Sum of file lengths of all subsequent files>,<free memory on hard disk>, <1st file
name>,<1st file length>, <2nd file name>,<2nd file length>,....,<nth file name>, <nth file length>
Example:
"CORR:TSET:SEL 'SET1'"
"CORR:TSET:CAT?"
Characteristics: *RST value: --
SCPI: device-specific
Mode: R, A
[SENSe<1|2>:]CORRection:TSET:COMMent <string>
This command defines the comment for the selected transducer set. Prior to this command, the
command SENS:CORR:TSET:SEL must be sent.
Example:
"CORR:TSET:SEL 'SET1'"
"CORR:TSET:COMM 'SET FOR ANTENNA'"
Characteristics: *RST value: '' (empty comment)
SCPI: device-specific
Mode: R,A
[SENSe<1|2>:]CORRection:TSET:RANGe<1 to 10> <freq>,<freq>,<name>..
This command defines a partial range of the selected transducer set. The partial range is determined
by its start and stop frequencies plus a list of names of the assigned transducer factors. The ranges 1
to 10 must be sent in ascending order. Prior to this command, the command SENS:CORR:TSET:SEL
must be sent.
Parameter: <freq>,<freq>::= start frequency, stop frequency of the range
<name>...::= list of names for the assigned transducer factors.
The individual names must be characterized by single quotation marks (') and
separated by commas.
Example:
"CORR:TSET:SEL 'SET1'"
"CORR:TRAN:TSET:RANG 1MHZ,2MHZ,'FACTOR1,'FACTOR2'"
Characteristics: *RST value: -
SCPI: device-specific
Mode: R, A
6.164
Remote Control – Description of Commands
Operating Manual 1302.6163.12 - 03
SENSe Subsystem