R&S ESU Series Operating Manual page 617

R&S ESU
[SENSe<1|2>:]FMEasurement:LISN[:TYPE] TWOPhase | FOURphase | ESH3Z5 | ESH2Z5 |
ENV4200 | ENV216 | OFF
This command selects whether a V-network is driven automatically via the user port in the final
measurement and, if yes, which one:
TWOPhase and ESH3Z5
FOURphase and ESH2Z5
ENV4200
ENV216
OFF
Example:
":FME:LISN:TWOP"
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: R
[SENSe<1|2>:]FMEasurement:LISN:PHASe L1 | L2 | L3 | N[[,L1 | L2 | L3 | N],...]
This command selects the phases of the V-network on which level measurements are consecutively
performed in the final measurement. L2 and L3 are only available with four-line V-networks
(FMEasurement:LISN FOURphase | ENV4200).
Example:
":FME:LISN:PHAS L1,N"
Characteristics: *RST value: L1
SCPI: device-specific
Mode: R
[SENSe<1|2>:]FMEasurement:LISN:PEARth GROunded | FLOating[,GROunded | FLOating]
This command selects the ground settings on the V-network on which level measurements are
consecutively performed in the final measurement. This command is available only for certain
V-networks (FMEasurement:LISN FOURphase | TWOPhase | ESH3Z5 | ESH2Z5).
Example:
":FME:LISN:PEAR GRO,FLO"
Characteristics: *RST value: GRO
SCPI: device-specific
Mode: R
[SENSe<1|2>:]FMEasurement:LISN:FILTer:HPAS[:STATe] ON | OFF
This command selects the setting for the high pass on the V-network with which the level measurement
is performed in the final measurement. This command is available only for the R&S ENV 216 V-
network (FMEasurement:LISN ENV216).
Example:
":FME:LISN:FILT:HPAS ON"
Characteristics: *RST value: ON
SCPI: device-specific
Mode: R
6.178
R&S ESH3-Z5 (two phases and protective earth are controllable)
R&S ESH2-Z5 (four phases and protective earth are controllable)
R&S ENV 4200 (four phases are controllable)
R&S ENV 216 (two phases and highpass are controllable)
Remote control deactivated
Remote Control – Description of Commands
Operating Manual 1302.6163.12 - 03
SENSe Subsystem