R&S ESU Series Operating Manual page 246

R&S ESU
Trace read out via the normal trace subsystem. The first harmonic frequency can be
read out via the center frequency command.
THD value comma separated in % and dB:
Remote command:
Comma separated list of harmonic levels, for each harmonic one value:
Remote command:
NO. OF With the softkey NO. OF HARMONICS the number of harmonics which shall be
HARMONICS measured can be adjusted. The range is from 1 to 26.
Remote command:
HARMONIC The HARMONIC SWEEPTIME softkey allows to set the value how long the zero
SWEEPTIME span measurement on each harmonic frequency shall take place. This is an alias
softkey to the normal sweep time of the zero span, therefore the same parser com-
mand is to be used.
HARMONIC The softkey HARMONIC RBW AUTO disables the resolution bandwidth.
RBW AUTO
Remote command:
ADJUST The ADJUST SETTINGS softkey activates the frequency search in the frequency
SETTINGS range from before starting the harmonic measurement (if harmonic measurement
was started from frequency sweep) and the level adjust.
Remote command:
Operating Manual 1302.6163.12 - 03
CALC:MARK:FUNC:HARM:DIST? TOT
CALC:MARK:FUNC:HARM:LIST?
CALC:MARK:FUNC:HARM:NHAR <numerical
value>
CALC:MARK:FUNC:HARM:BAND:AUTO ON | OFF
CALC:MARK:FUNC:HARM:PRES
Instrument Functions
Analyzer Mode
4.215