R&S ESU Series Operating Manual page 673

R&S ESU
STATus:QUEStionable:TRANsducer:PTRansition 0 to 65535
This command sets the edge detectors of all bits of the STATus:QUEStionable:TRANsducer register
from 0 to 1 for the transitions of the CONDition bit.
Example:
"STAT:QUES:TRAN:PTR 65535"
Characteristics: *RST value: –
SCPI: device-specific
Mode: R, A
STATus:QUEStionable:TRANsducer:NTRansition 0 to 65535
This command sets the edge detectors of all bits of the STATus:QUEStionable:TRANsducer register
from 1 to 0 for the transitions of the CONDition bit.
Example:
"STAT:QUES:TRAN:NTR 65535"
Characteristics: *RST value: –
SCPI: device-specific
Mode: R, A
STATus:QUEue[:NEXT]?
This command returns the earliest entry to the error queue and deletes it.
Positive error numbers indicate device-specific errors, negative error numbers are error messages
defined by SCPI (cf. chapter
error", is returned. This command is identical with the command SYSTem:ERRor.
Example:
"STAT:QUE?"
Characteristics: *RST value: –
SCPI: conform
Mode: R, A
6.234
"Error Messages"). If the error queue is empty, the error number 0, "no
Remote Control – Description of Commands
Operating Manual 1302.6163.12 - 03
STATus Subsystem