External Generator Settings - R&S ESU Series Operating Manual

R&S ESU
The external generator control is only available in the spectrum analyzer mode
and not in the receiver mode.
4.11.1

External Generator Settings

NETWORK The NETWORK hotkey opens the menu for setting the functions of the external gen-
erator.
SOURCE POWER
POWER OFFSET
SOURCE CAL
FREQUENCY OFFSET
EXT SOURCE
Other softkeys are available in the displayed menus for controlling the internal
tracking generator when option Tracking Generator R&S FSU-B9 is fitted. For
detailed information see section
page
SOURCE The SOURCE POWER softkey activates the entry of the generator output level. The
POWER value range depends on the selected generator. For detailed information see
Generator Types Supported by the R&S ESU" on page
If both option External Generator Control B10 and option Tracking Generator B9 are
installed, the softkey will modify the output power of the generator currently in use.
The default output power is -20 dBm.
Remote command:
POWER The POWER OFFSET softkey activates the entry of a constant level offset of the
OFFSET
generator. With this offset, attenuator pads or amplifiers connected to the output
connector of the generator can be handled during the input and output of output lev-
els.
4.334
!
CAL TRANS
CAL REFL SHORT
CAL REFL OPEN
NORMALIZE
REF VALUE POSITION
REF VALUE
RECALL
SAVE AS TRD FACTOR
!
EXT SRC ON / OFF
SELECT GENERATOR
FREQUENCY SWEEP
GEN REF INT / EXT
4.283.
SOUR:EXT:POW –20dBm
External Generator Control – Option R&S FSP-B10
"Tracking Generator – Option R&S FSP-B9" on
4.347.
Operating Manual 1302.6163.12 - 03
Instrument Functions
"List of