R&S ESU Series Operating Manual page 44

R&S ESU
For description of the softkeys see the following menus:
RECEIVER FREQUENCY
ADD TO PEAK LIST
DETECTOR
MEAS TIME
DEMOD
THRESHOLD SCAN
FINAL MEAS
RUN PRE SCAN+FINAL
RUN SCAN
Side menu
CONTUNOUOS BARGRAPH
SINGLE BARGRAPH
Remote command:
In the receiver mode the R&S ESU measures the level at the set frequency with a
selected bandwidth and measurement time (see also
"MEAS TIME" on page
"DETECTOR" on page
The functions for data reduction and the control of line impedance simulating net-
work are available in the THRESHOLD SCAN and FINAL MEAS submenus.
A frequency scan can be performed after setting the start and stop frequency and
the step width. The scan subranges can be defined in a table (DEFINE SCAN soft-
key).
The scan is started with the RUN SCAN softkey. In operating mode RECEIVER, the
RECEIVER hotkey and the MEAS hotkey directly open the RECEIVER menu. For a
detailed description refer to
on page
The R&S ESU is fitted with a preselection with switchable preselection. Preselection
is always switched on in receiver mode.
Operating Manual 1302.6163.12 - 03
INST REC
4.31). Signal weighting is by means of detectors (see also
4.29).
"Selection of the Measurement Function – MEAS Key"
4.25.
"Operation on a Discrete Frequency – FREQ
Key" on page 4.14 or "Selection of the Mea-
surement Function –
page 4.25
"Selection of the Measurement Function –
MEAS Key" on page 4.25
"Selecting the Detector" on page 4.28
"Setting the Measurement
page 4.30
"AF Demodulators" on page 4.33
"Automatic Final Measurement with Thresh-
old Scan" on page 4.35
"Data Reduction and
page 4.33
"Running a Scan" on page 4.62
"Running a Scan" on page 4.62
"Selection of the Measurement Function –
MEAS Key" on page 4.25
"Selection of the Measurement Function –
MEAS Key" on page 4.25
"RES BW" on page 4.21
Instrument Functions
Receiver Mode
MEAS Key" on
Time" on
Peak List" on
and
4.13