R&S ESU Series Operating Manual page 672

R&S ESU
STATus:QUEStionable:FREQuency:PTRansition 0 to 65535
This command sets the edge detectors of all bits of the STATus:QUEStionable:FREQuency register
from 0 to 1 for the transitions of the CONDition bit.
Example:
"STAT:QUES:FREQ:PTR 65535"
Characteristics: *RST value: –
SCPI: device-specific
Mode: R, A
STATus:QUEStionable:FREQuency:NTRansition 0 to 65535
This command sets the edge detectors of all bits of the STATus:QUEStionable:FREQuency register
from 1 to 0 for the transitions of the CONDition bit.
Example:
"STAT:QUES:FREQ:NTR 65535"
Characteristics: *RST value: –
SCPI: device-specific
Mode: R, A
STATus:QUEStionable:TRANsducer[:EVENt]?
This command queries the contents of the EVENt section of the STATus:QUEStionable:TRANsducer
register. Readout deletes the contents of the EVENt section.
Example:
"STAT:QUES:TRAN?"
Characteristics: *RST value: –
SCPI: device-specific
Mode: R, A
STATus:QUEStionable:TRANsducer:CONDition?
This command queries the contents of the CONDition section of the STATus:QUEStionable:
FREQuency register. Readout does not delete the contents of the CONDition section.
Example:
"STAT:QUES:TRAN:COND?"
Characteristics: *RST value: –
SCPI: device-specific
Mode: R, A
STATus:QUEStionable:TRANsducer:ENABle 0 to 65535
This command sets the bits of the ENABle section of the STATus:QUEStionable:TRANsducer register.
The ENABle register selectively enables the individual events of the associated EVENt section for the
sum bit in the status byte.
Example:
"STAT:QUES:TRAN:ENAB 65535"
Characteristics: *RST value: –
SCPI: device-specific
Mode: R, A
Operating Manual 1302.6163.12 - 03
Remote Control – Description of Commands
STATus Subsystem
6.233