Mode Selection - Hotkey Bar - R&S ESU Series Operating Manual

R&S ESU
4.3 Mode Selection – Hotkey Bar
For fast mode selection the R&S ESU has keys located under the measurement
screen, the so-called hotkeys. These hotkeys are displayed depending on the
options installed on the instrument. According to the selected mode, the correspond-
ing softkey menus are displayed (on the right side of the measurement screen).
In this section, only the hotkeys provided by the basic model are described. For
information on the other hotkeys refer to the corresponding option descriptions.
Fig. 4.1 Hotkey bar of the basic model
SPECTRUM The SPECTRUM hotkey sets R&S ESU to analyzer mode. For details on the softkey
menus refer to section
Remote command:
RECEIVER The RECEIVER hotkey sets the R&S ESU in the test receiver mode.
Remote command:
IF The IF hotkey activates the IF analysis mode.
Remote command:
APD The APD hotkey activates the CISPR weighting function for measuring the Ampli-
tude Probability Distribution (APD) of a disturbance signal.
Remote command:
MORE The MORE hotkey switches to side hotkey bar(s) and back to the main hotkey bar.
In the side hotkey bar(s), the hotkeys for the options are located. For further infor-
mation refer to the descriptions of the corresponding options.
SCREEN A / With the SCREEN A / SCREEN B hotkey two different settings can be selected on
SCREEN B the R&S ESU in the FULL SCREEN display mode.
In the SPLIT SCREEN display mode the key switches between active diagram A
and B.
The key designation indicates the diagram which has been activated by means of
the key.
The currently active window is marked by
gram.
Remote command:
Operating Manual 1302.6163.12 - 03
"Analyzer Mode" on page
INST:SEL SAN
INST:NSEL 1
INST:SEL REC
INST:NSEL 6
INST: IFAN
INST:SEL APD
A
DISP:WIND<1|2>:SEL A
Instrument Functions
Mode Selection – Hotkey Bar
4.102.
or on the right of the dia-
B
4.9