R&S ESU Series Operating Manual page 285

R&S ESU
The active window is marked by
Remote command:
SPLIT
The SPLIT SCREEN softkey selects the display of two diagrams. The upper dia-
SCREEN gram is designated SCREEN A, the lower diagram SCREEN B.
Switching between SCREEN A and SCREEN B is performed via the corresponding
key in the hotkey bar. The active window is marked by highlighting fields
B
In receiver mode, screen A displays the receiver bar graph and screen B the scan
diagram or the IF analysis diagram.
Remote command:
PARAM
The PARAM COUPLING softkey opens a submenu and a table to select the coupled
COUPLING
parameters of receiver and analyzer mode.
All analyzer traces in MAX HOLD, MIN HOLD or AVERAGE mode are set to VIEW
after switching to receiver or mixed mode and back to analyzer mode.
Limit lines keep active when switching between analyzer and receiver mode.
COUPLING TABLE
DEFAULT CONFIG
ENABLE ALL ITEMS
DISABLE ALL ITEMS
COUPLING The COUPLING TABLE softkey opens the PARAMETER COUPLING table.
TABLE
Remote command:
4.254
on the right of the diagram.
Analyzer Center
Start-Stop
Attenuation, Unit
A or on the right of the diagram.
B
DISP:FORM SING
DISP:WIND<1|2>:SEL
DISP:FORM SPL
INST:COUP:CENT ALL
INST:COUP:SPAN ALL
INST:COUP:ATT ALL
Operating Manual 1302.6163.12 - 03
Instrument Functions
Basic Settings
A and