R&S ESU Series Operating Manual page 702

Emi test receiver

Table of Contents

6.23 GPIB Commands of HP Models 856xE, 8566A/B,

8568A/B and 8594E

Introduction

The R&S FSP analyzer family supports a subset of the GPIB commands of HP models 8560E, 8561E,

8562E, 8563E, 8564E, 8565E, 8566A, 8566B, 8568A, 8568B and 8594E.

Despite the differences in system architecture and device features, the supported commands have been

implemented in a way to ensure a sufficiently high degree of correspondence with the original.

This includes the support of syntax rules for not only newer device families (B and E models) but for the

previous A family as well.

In many cases the selection of commands supported by the R&S ESU is sufficient to run an existing

GPIB program without adaptation.

The device model to be emulated is selected manually by means of the key sequence SETUP - GEN-

ERAL SETUP - GPIB - GPIB LANGUAGE via the GPIB using the SYSTem:LANGuage command.

To make it possible to also emulate device models that are not part of the selection list of the GPIB LAN-

GUAGE softkey, the identification string received in response to the ID command can be modified (key

sequence SETUP - GENERAL SETUP - GPIB - ID STRING USER). This allows any device model to be

emulated whose command set is compatible with one of the supported device models.

Command Set of Models 8560E, 8561E, 8562E, 8563E, 8564E,

8565E, 8566A/B, 8568A/B, 8591E, 8594E, 71100C, 71200C, and

As with the original units, the R&S ESU includes the command set of the A models in the command set

of the B models.

The HP model 8591E is compatible to HP model 8594E, the HP models 71100C,

71200C, and 71209A are compatible to HP models 8566A/B.

Supported subset

Operating Manual 1302.6163.12 - 03

GPIB Commands of HP Models 856xE, 8566A/B, 8568A/B and 8594E

Clear/Write A

Stop previous

Remote Control – Description of Commands

Corresponding

available in V4.1x and above

Show Quick Links

Chapters

Table of Contents