R&S ESU Series Operating Manual page 223

R&S ESU
EDIT ACP The EDIT ACP LIMITS softkey opens a table for defining the limits for the ACP mea-
LIMITS surement.
The following rules apply for the limits:
• A separate limit can be defined for each adjacent channel. The limit applies to both
the upper and the lower adjacent channel.
• A relative and/or absolute limit can be defined. The check of both limit values can
be activated independently.
• The R&S ESU checks adherence to the limits irrespective of whether the limits are
absolute or relative or whether the measurement is carried out with absolute or
relative levels. If both limits are active and if the higher of both limit values is
exceeded, the measured value is marked accordingly.
Measured values exceeding the limit are marked by a preceding asterisk.
Remote command:
WEIGHTING Opens a submenu to control the weighting filter.
FILTER
Some of the digital standards specify weighting filters to be taken into account. In
that case the required filter is automatically activated by the selection of the ACP
standard.
4.192
CALC:LIM:ACP ON
CALC:LIM:ACP:ACH 0dB,0dB
CALC:LIM:ACP:ACH:STAT ON
CALC:LIM:ACP:ACH:ABS –10dBm,-10dBm
CALC:LIM:ACP:ACH:ABS:STAT ON
CALC:LIM:ACP:ALT1 0dB,0dB
CALC:LIM:ACP:ALT1:STAT ON
CALC:LIM:ACP:ALT1:ABS –10dBm,-10dBm
CALC:LIM:ACP:ALT1:ABS:STAT ON
CALC:LIM:ACP:ALT2 0dB,0dB
CALC:LIM:ACP:ALT2:STAT ON
CALC:LIM:ACP:ALT2:ABS –10dBm,-10dBm
CALC:LIM:ACP:ALT2:ABS:STAT ON
Operating Manual 1302.6163.12 - 03
Instrument Functions
Analyzer Mode