R&S ESU Series Operating Manual page 333

R&S ESU
The Save dialog box offers the following selectable data subsets in the Items field.
Current Settings
All Limit Lines
All Transducer
All Transducers
All Traces
Source Cal Data
Scan Channel List
Peak-Final List
SELECT ITEMS The SELECT ITEMS softkey sets the focus on the Items field to select the appropri-
ate item to be stored.
ENABLE ALL The ENABLE ALL ITEMS softkey marks all partial data sets.
ITEMS
Remote command:
DISABLE ALL The DISABLE ALL ITEMS softkey deselects all partial data sets.
ITEMS
Remote command:
4.302
These settings include:
• current configuration of general instrument parameters
• current measurement hardware settings
• active limit lines:
A data set may contain maximum 8 limit lines for each
window. It always contain the activated limit lines and the
de-activated limit lines used last, if any. Consequently, the
combination of the restored deactivated limit lines depends
on the sequence of use with command MMEM:LOAD.
• the activated transducer factor
• user-defined color settings
• configuration for hardcopy output
• active transducer set:
A data set may contain maximum 4 transducer factors. It
always contain the activated factors and the factors used
and de-activated last, if any. Consequently, the combination
of the restored deactivated transducer factors depends on
the sequence of use with the command MMEM:LOAD.
• peak list or final measurement results
(receiver mode)
• settings of tracking generator
(only with option R&S ESU B9)
all limit lines
all transducer factors
all transducer
all traces which are not blanked
correction data for tracking generator
(only with options R&S ESU B9 or R&S ESU B10)
adds the channel lists to the list of data subsets of a save/
recall device setting.
(only with option R&S ESU K50)
peak list or final measurement results
MMEM:SEL:ALL
MMEM:SEL:NONE
Operating Manual 1302.6163.12 - 03
Instrument Functions
Basic Settings