R&S ESU Series Operating Manual page 765

R&S ESU
Differences in GPIB Behavior between the FSP and the FSE Families of Instruments
Devices Command (Sheet 38 of 47)
R&S [SENSe<1|2>:]MPOWer[:SEQuence]
ESU
R&S [SENSe<1|2>:]MPOWer:RESult[:LIST]?
ESU
R&S [SENSe<1|2>:]MPOWer:RESult:MIN?
ESU
FSE [SENSe<1|2>:]MSUMmary:AHOLd[:STATe]
FSE [SENSe<1|2>:]MSUMmary:MODE
FSE [SENSe<1|2>:]MSUMmary:MTIMe
FSE [SENSe<1|2>:]MSUMmary:REFerence
FSE [SENSe<1|2>:]MSUMmary:REFerence:AUTO
FSE [SENSe<1|2>:]MSUMmary:RUNit
FSET [SENSe<1|2>:]PM[:DEViation]:RANGe[:UPPer]
R&S FSE [SENSe<1|2>:]POWer:ACHannel:ACPairs
ESU
R&S FSE [SENSe<1|2>:]POWer:ACHannel:
ESU BANDwidth|BWIDth:ACHannel
R&S FSE [SENSe<1|2>:]POWer:ACHannel:
ESU BANDwidth|BWIDth:ALTernate<1|2>
R&S FSE [SENSe<1|2>:]POWer:ACHannel:
ESU BANDwidth|BWIDth[:CHANnel]
R&S FSE [SENSe<1|2>:]POWer:ACHannel:MODE
ESU
R&S FSE [SENSe<1|2>:]POWer:ACHannel:PRESet
ESU
R&S [SENSe<1|2>:]POWer:ACHannel:PRESet:RLEVel
ESU
6.326
Remote Control – Description of Commands
Parameter Notes
<analyzer freq>, new function for
<rbw>, R&S ESU
<meas time>,
<trigger source>,
<trigger level>,
<trigger offset>,
<type of meas>,
<# of meas>
new function for
R&S ESU
new function for
R&S ESU
ON | OFF not available for
R&S ESU and FSET
ABSolute | RELative not available for
R&S ESU and FSET
0.1S | 1S not available for
R&S ESU and FSET
<numeric_value> not available for
R&S ESU and FSET
ONCE not available for
R&S ESU and FSET
PCT | DB not available for
R&S ESU and FSET
<numeric_value> not available for
R&S ESU
0 to 3 R&S ESU: new
parameter value 0 for
channel power
measurement
100 to 1000MHz R&S ESU: parameter
range starts at 100Hz
FSE: parameter range
starts at 0 Hz
100 to 1000MHz R&S ESU: parameter
range starts at 100Hz
FSE: parameter range
starts at 0 Hz
100 to 1000MHz R&S ESU: parameter
range starts at 100Hz
FSE: parameter range
starts at 0 Hz
ABSolute | RELative
ACPower | CPOWer | MCACpower not
OBANdwidth | OBWidth | available for FSE
CN | CN0 | MCACpower
new function for
R&S ESU
Operating Manual 1302.6163.12 - 03