Change Of Settings Via Markers - Mkr-> Key - R&S ESU Series Operating Manual

R&S ESU
4.6.4 Change of Settings via Markers – MKR-> Key
The MKR-> menu offers functions through which instrument parameters can be
changed with the aid of the currently active marker. The functions can be used on
markers and delta markers.
On opening the menu, the entry for the last active marker is activated; if no marker
was enabled, MARKER 1 is activated and a peak search is performed.
MKR->
SELECT MARKER
PEAK
CENTER=MKR FREQ
NEXT PEAK
NEXT PEAK RIGHT
NEXT PEAK LEFT
SEARCH LIMITS
MKR->TRACE
Side menu
MKR->CF STEPSIZE
MIN
NEXT MIN
NEXT MIN RIGHT
NEXT MIN LEFT
PEAK EXCURSION
Side menu
AUTO MAX PEAK | AUTO
MIN PEAK
SELECT
The SELECT MARKER softkey activates the numerical selection of the marker in
MARKER
the data entry field.
For further information refer to the descriptions in section
"SELECT MARKER" on page
PEAK
The PEAK softkey sets the active marker or delta marker to the peak of the trace.
For further information refer to the descriptions in section
on page
CENTER=MKR The CENTER=MKR FREQ softkey sets the center frequency to the current marker
FREQ or delta marker frequency.
A signal can thus be set to the center of the frequency display range, for example,
so that it can then be examined in detail with a smaller span.
Remote command:
Operating Manual 1302.6163.12 - 03
!
LEFT LIMIT RIGHT LIMIT
THRESHOLD
SEARCH LIMIT OFF
4.66.
4.66.
CALC:MARK:FUNC:CENT
Instrument Functions
IF Spectrum Analysis Mode
"Receiver Mode"
"Receiver Mode" – "PEAK"
4.85
–