R&S ESU Series Operating Manual page 307

R&S ESU
The table with the data of the marked set (the EDIT softkey) or an empty table in
which the following entries are preset (the NEW softkey) is displayed:
Unit:
Break:
The characteristics of the set can be entered in the header field of the table, the sub-
ranges in the columns of the set.
Name
Unit
Break
Comment
Start
Stop
Factors
An overwritten transducer set remains stored in the background as long as the
edited factor is stored with the SAVE TRD SET softkey or until the table is closed. A
set overwritten by mistake can be restored by leaving the entry.
Name - Entry of name
A maximum of 8 characters is permissible for the name. The characters have to
comply with the convention of DOS file names. If the name exceeds 8 characters,
the name is truncated. The unit automatically stores all transducer sets with the
extension .TDS.
If an existing name is changed, the set stored under the previous name is retained
and will not be overwritten automatically with the new name. The previous set can
be deleted at a later time using DELETE FACTOR/SET. Thus, sets can be copied.
Remote command:
Unit - Selection of unit
The unit of the transducer set is selected from a selection box activated by the
ENTER key.
The unit should be selected prior to the entry as it determines the settable trans-
ducer factors. The preset unit for new sets is "dB".
4.276
dB
OFF
Entry of the name
Selection of unit
Activating the query when changing the subrange
Entry of a comment
Entry of the start frequency of the subrange
Entry of the stop frequency of the subrange
Selection of the transducer factors for the subrange
CORR:TSET:SEL <name>
Instrument Functions
Operating Manual 1302.6163.12 - 03
Basic Settings