R&S ESU Series Operating Manual page 249

R&S ESU
In the SWEEP LIST table, the individual sweep ranges are set.
Range Start:
Range Stop:
Filter Type:
RBW:
VBW:
VBW:
Sweep Time Mode:
Sweep Time:
Detector:
REF-Level:
RF-Attenuator-Mode: AUTO, MANUAL
RF-Attenuator:
PRE-AMP:
Sweep Points:
Stop after Sweep:
Transd. factor:
Limit check:
Limit:
Remote command:
INS BEFORE The INS BEFORE RANGE softkey inserts a range in front of the marked line.
RANGE
Remote command:
INS AFTER The INS AFTER RANGE softkey inserts a range following the marked line.
RANGE
Remote command:
4.218
Start frequency of the range
Stop frequency of the range
NORMAL (3dB), EMI (6dB), CHANNEL, RRC, 5-POLE
Resolution filter bandwidth
Video filter bandwidth
Video filter bandwidth; not applicable for CHANNEL and RRC
filters
AUTO, MANUAL
Sweep time; if AUTO is indicated for the sweep time mode, the
automatically calculated sweep time is displayed. If the cell is
edited, the associated sweep time mode is automatically set to
MANUAL.
Specifies the range detector:
AUTO PEAK, MAX PEAK, MIN PEAK, SAMPLE, RMS, AVER-
AGE
Reference level in dBm
The upper edge of the displayed screen area is the value of
the maximum reference level, corrected by the associated
transducer factor.
Number; as with Sweep Time
ON, OFF
preamplifier selection (options B23, B25, if available)
Number of sweep points per range (sweep segment). The
maximum number of sweep points is 8001.
ON, OFF
if ON, the sweep is stopped after the range and continued only
if confirmed by you via a message box (bit 10 of the
OPERation Register" on page
NONE or factor (enter via selection list)
ON, OFF (common for all ranges)
Limit in dBm (enter via selection list)
A temporary limit line _SPUL_IN_ is used, based on the range
limits. This temporary limit line is created at measurement start
and may be copied for other purposes.
SENS:LIST:RANG<1...20>:...
--
--
Instrument Functions
Analyzer Mode
5.24).
Operating Manual 1302.6163.12 - 03
"STATus: