R&S ESU Series Operating Manual page 76

R&S ESU
INTER The INTERACTIVE softkey selects the interactive mode for the final measurement
ACTIVE as described above.
Remote command:
MEASURE The MEASURE softkey continues with the final measurement. The final measure-
ment starts at the next frequency entry on the peak list or at a marked frequency if
one or several lines have been skipped with the SKIP FREQUENCY softkey.
Remote command:
STOP The STOP FINAL MEAS softkey halts the final measurement. The final measure-
FINAL MEAS ment starts from the beginning on a new start. The previously collected data is lost.
Remote command:
Sequence for INTER ACTIVE
HOLD SCAN
STOP SCAN
With the final measurement halted all receiver settings can be modified for example
for examining the signal in detail.
The mode of the measurement (automatic or interactive) can be selected again. The
final measurement can be skipped. The highest level measured can be sccepted by
GET MAXHOLD. The final measurement can be started with the MEASURE softkey.
Remote command:
AUTOMATIC The AUTOMATIC FINAL softkey selects the automatic mode for the final measure-
FINAL ment (see above).
Remote command:
INTER The INTERACTIVE softkey selects the interactive mode for the final measurement
ACTIVE as described above.
Remote command:
SIKP The SIKP FREQUENCY softkey skips the final measurement and continues with the
FREQUENCY prescan.
Remote command:
Operating Manual 1302.6163.12 - 03
:FME:AUTO OFF
--
--
AUTOMATIC FINAL
INTER ACTIVE
SIKP FREQUENCY
GET MAXHOLD
MEASURE
STOP FINAL MEAS
--
:FME:AUTO ON
:FME:AUTO OFF
--
Instrument Functions
Receiver Mode
4.45