R&S ESU Series Operating Manual page 317

R&S ESU
CONFIGURE The CONFIGURE NETWORK softkey opens the following submenu:
NETWORK
COMPUTER NAME
IP ADDRESS
SUBNET MASK
DHCP ON | OFF
CONFIGURE
NETWORK
SHOW CONFIG
The Network Configuration softkeys above are available from firmware Version
4.3x.
Instruments shipped with Windows XP Service Pack1 require an additional instal-
lation package (LXI installer) if the softkeys are not visible. This installation pack-
age is available on the R&S instrument's download area.
The configuration via softkeys is only possible if the LAN is connected to the
instrument.
COMPUTER The COMPUTERNAME softkey opens a dialog to enter the computer name. The
NAME naming conventions of Windows apply.
For more details see the Quick Start Guide 6,
IP ADDRESS The IP ADDRESS softkey opens a dialog to configure the instrument's IP address.
The TCP/IP protocol is preinstalled with the IP address 10.0.0.10. If the DHCP
server is available (DHCP ON) the softkey is not available.
For more details see the Quick Start Guide 6,
SUBNET MASK The SUBNET MASK softkey opens a dialog to configure the instrument's TCP/IP
subnet mask. The TCP/IP protocol is preinstalled with the subnet mask
255.255.255.0.
The subnet mask consists of four number blocks separated by dots. Each block con-
tain 3 numbers in maximum (e.g.100.100.100.100), but also one ore two numbers
are allowed in a block (as an example see the preinstalled address).
For more details see the Quick Start Guide 6,
DHCP ON | OFF If the DHCP softkey is set ON, a new IP address is assigned each time the instru-
ment is restarted. This address must first be determined on the instrument itself.
To avoid problems, use a fixed IP address.
Using a DHCP server is not suitable for remote operation of the R&S FSU.
4.286
Instrument Functions
" LAN Interface".
" LAN Interface".
" LAN Interface".
Operating Manual 1302.6163.12 - 03
Basic Settings